Bruksanvisning Philips QG3040 Skjeggtrimmer

Bruksanvisning

ENGLISH

General description (fig. 1)

.

A 2D Contour Tracking beard trimmer comb

B Trimming attachment

C Hair length selector

D Release button

E On/off slide

F Socket for appliance plug

G Cleaning brush

H Barber's comb

I Charging light

J Powerplug

K Appliance plug

L Nose/ear/eyebrow attachment

M Charging stand with storage facility

N Precision attachment (only HQG 267 and QG 3040)

Important

.

Read these instructions for use carefully before using the

appliance and save them for future reference.

◗ Check if the voltage indicated on the powerplug

corresponds to the local mains voltage before you

connect the appliance.

◗ Only use the powerplug supplied to charge the appliance.

Do not cut off the powerplug to replace it with another

plug, as this will cause a hazardous situation.

◗ If the powerplug is damaged, always have it replaced by

one of the original type in order to avoid a hazard.

◗ Make sure the appliance, the charging stand and the

powerplug do not get wet.

◗ Charge, use and store the appliance at a temperature

between 15cC and 35cC.

◗ This appliance is only intended for trimming and

grooming the human beard, moustache, sideburns, nose

hair, ear hair and eyebrows.

◗ Keep the appliance out of the reach of children.

◗ Do not use the appliance when one of the attachments

is damaged or broken, as this may cause injury.

◗ Do not place the beard trimmer comb on the precision

attachment.

Charging

.

Charge the appliance fully before you start using it for the

first time or after a long period of disuse.

It will take approx. 10 hours to fully charge the battery. A

fully charged appliance has a cordless operating time of up to

35 minutes. When you charge the appliance for 3 hours, you

can use it for 15 minutes.

The appliance does not run from the mains.

Make sure the appliance is switched off during charging!

You can charge the appliance in 2 different ways:

1 In the charging stand:

◗ Insert the appliance plug into the socket in the bottom

of the stand (fig. 2).

◗ Place the appliance on the pin of the stand (fig. 3).

2 Outside the charging stand:

◗ Insert the appliance plug directly into the appliance

(fig. 4).

◗ The green charging light on the powerplug indicates

that the appliance is charging (fig. 5).

Optimise the lifetime of the rechargeable battery

◗ Do not leave the appliance plugged into the wall socket

for more than 24 hours.

◗ Discharge the battery completely twice a year by letting

the motor run until it stops. Then fully recharge the

battery.

Preparing for use

.

◗ Always comb the hair with a fine comb in the direction

of growth before you start trimming.

◗ Make sure that the hair is dry and clean.

Using the appliance

.

Beard trimming with comb

1 Put the beard trimmer comb on the trimming attachment

and push it home until you hear a click (fig. 6).

2 Press the hair length selector and slide it to the desired

setting. See table I (fig. 7).

The setting selected will appear in the window to the left of

the hair length selector.

B

When you are trimming for the first time, start at the

maximum trimming length setting (9) to familiarise yourself

with the appliance.

B

Using setting 1 with the comb installed will result in a

'stubble look'.

3 To trim in the most effective way, move the appliance

against the direction of hair growth (fig. 8).

Do not move the appliance too fast. Make smooth and

gentle movements and make sure the surface of the comb

always stays in contact with the skin.

If a lot of hair has accumulated in the comb, remove the

comb and blow and/or shake the hair out of the comb.

NB: You have to adjust the trimming length again after you

have removed the comb!

Beard trimming without comb

1 Remove the comb by pressing and sliding the hair length

selector upwards (fig. 9).

Never pull at the flexible top of the comb. Always pull at the

bottom part.

2 Make well-controlled movements and touch your beard

only slightly with the trimming attachment.

Cutting without the comb will result in a very short stubble

beard.

Defining beard, moustache and sideburns (only HQG

267 and QG 3040)

1 Remove the beard trimmer comb by pressing and

sliding the hair length selector upwards (fig. 9).

2 Detach the trimming attachment by pushing the release

button (fig. 10).

3 Put the precision attachment on the appliance (fig. 11).

◗ Hold the appliance upright when you use the precision

attachment (fig. 12).

Grooming facial hair (nose hair, ear hair and eyebrows)

1 Remove the comb (fig. 9).

2 Remove the trimming attachment (fig. 10).

3 Put the nose/ear/eyebrow attachment on the appliance

(fig. 13).

Trimming nose hair

1 Make sure your nostrils are clean.

2 Switch the appliance on and insert the tip of the

attachment into one of your nostrils (fig. 14).

Do not insert the tip more than 0.5 cm into your nostril.

3 Slowly move the tip in and out while turning it round at

the same time to remove unwanted hair.

To reduce the tickling effect, make sure that the side of the

tip is firmly pressed against the skin.

Trimming ear hair

1 Clean the outer ear channel. Make sure it is free from

wax.

2 Switch the appliance on and move the tip softly round

the ear to remove hairs sticking out beyond the rim of

the ear (fig. 15).

3 Carefully insert the tip into the outer ear channel (fig. 16).

Do not insert the tip more than 0.5 cm into the ear channel

as this could damage the eardrum.

4203 000 53753

2/13

Vurdering

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for Philips QG3040 Skjeggtrimmer. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter Philips. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til Philips QG3040 Skjeggtrimmer på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Alle bruksanvisninger for Philips Skjeggtrimmere
Flere håndbøker for Skjeggtrimmere

Ofte stilte spørsmål om Philips QG3040 Skjeggtrimmer

Vårt supportteam søker etter nyttig produktinformasjon samt svar på ofte stilte spørsmål. Hvis du finner en feil i våre ofte stilte spørsmål, vennligst gi oss beskjed ved å benytte vårt kontaktskjema.

Relaterte produkter

Bruksanvisning

Philips MG3713 Skjeggtrimmer

Bruksanvisning

Philips QT4000 Skjeggtrimmer

Bruksanvisning

Philips BT7085 Skjeggtrimmer

Bruksanvisning

Philips BT3216 Skjeggtrimmer

Bruksanvisning

Philips BT3221 Skjeggtrimmer

Bruksanvisning

Philips QT4003 Skjeggtrimmer

Bruksanvisning

Philips BT5520 Skjeggtrimmer

Bruksanvisning

Philips BT5503 Skjeggtrimmer

Relaterte kategorier