Bruksanvisning Lotus Professional enMotion Impulse Håndkledispenser

Bruksanvisning

Congratulations on choosing to improve the hygiene and cleanliness of your wash-

room. Lotus Professional’s new touchless enMotion® Impulse handtowel dispensing

system uses tomorrow’s innovation and increased hand drying capacity to answer

today’s need for more e cient hygienic solutions. Your choice has conveyed a com-

mitment to providing a hygienic washroom environment and a quality image, and

to improving the service in your washroom.

Tools and supplies

• Screwdriver

• Power Drill

• Pencil or Pen

• Spirit level (recommended)

• 4 ea. #8 Screws included

■ STEP ONE

Unpacking the Dispenser

Open case and locate listed components:

• enMotion® Impulse handtowel dispenser

• Dispenser Key

• 3 LR20 D-Cell Alkaline Batteries

• Instruction Guide

■ STEP TWO

Assembling the Dispenser

1. Locate key on bottom of dispenser and open dispenser.

2. Unwrap cellophane from batteries.

3. Load 3 LR20 D-Cell Alkaline Batteries in battery compartment located in the rear of

the dispenser. A red light appears when batteries are properly installed.

4. Close dispenser. The red light will shut o

■ STEP THREE

Determining installation location

1. When placing dispenser, allow at least

10 cm clearance on all sides

2. Use template printed on the case to locate

screw holes.

Note: Using existing screw holes where

possible may simplify mounting process.

■ STEP FOUR

Mounting the dispenser template printed on the case

1. Align dispenser with screw holes. Check that the dispenser is level. Insert one screw

through slot in back of the cabinet. Tighten screw.

2. Insert each remaining screw through screw slots. Tighten all screws.

■ STEP FIVE

Loading  rst roll

(See step 1-4)

1. Place the roll as indicated in the picture 1

2. Pull towel downward and onto the rollers

3. Press the paper feed button on the lower left of the dispenser

4. Once the paper feeds through the bottom, tear o the sheet and discard.

■ STEP SIX

Adjusting the Settings

The enMotion® Impulse dispenser’s adjustable settings are located inside the dispenser on

the lower left side.

1. The “Adjustable Sheet Length” (ASL) system allows for adjustments in towel sheet

length. The sheet lengths are:

• “S” Short towel (maximum number of hand dries)

• “M” Medium towel (optimal hand dry capacity)

• “L” Long towel (largest available towel)

Note: The ASL system is pre-set at the “L” option. Set ASL to meet your needs.

2. The “Adjustable Time Delay” (ATD) system allows towels to dispense at di erent time

delay intervals after a towel is removed from the dispenser. Settings are:

• “S” Short Delay

• “M” Medium Delay

• “L” Long Delay

Note: The ATD system is pre-set at the “M” option. Set ATD to meet your needs.

3. The “The Dispense Mode” (DM) system allows for adjustment in how the towel is

presented to the end user. Settings are:

• “On Demand” (The towel will feed from the dispenser after the end user has

activated the sensor.)

• “Hanging Towel” (The towel will always be showing. After tearing o a towel,

another towel will present itself.)

Note: The DM system is pre-set at the “On Demand” option. Set DM to meet your

needs.

■ STEP SEVEN

Operating the Dispenser

1. Dispensing enMotion Towels

A. Wave hand approximately 5 cm across front of dispenser. An enMotion Towel is

automatically dispensed.

B. Once towel is dispensed, tear towel to dry hands. A second towel cannot be

dispensed until the  rst towel is removed. After the towel is removed, a short

delay will occur to avoid paper waste.

Note: To adjust the delay, see Step 6, “Adjusting Settings.”

2. Replacing Batteries

A. The “low battery” light is located on the motion sensor and indicates that the

battery power is low.

Note: When indicator light appears, dispenser will continue to operate for a

limited period of time.

B. Replace batteries with 3 LR20 D-Cell alkaline batteries. Non-alkaline batteries

will have reduced life.

C. Load batteries as indicated on the diagram located on the inside lid of the battery

compartment.

■ STEP EIGHT

Troubleshooting the Dispenser

Dispense towels by moving hand in front of dispenser within sensor range and immediately

tear o towel. Repeat this procedure 1-2 times to con rm proper operation. If towel does

not dispense when moving hand in front of dispenser, open the dispenser and check the fol-

lowing:

1. Check inside the paper chute for a paper jam. If necessary, clear.

2. Check that towel is properly loaded.

3. Advance towel using paper feed button to con rm power.

4. If no power, check batteries to con rm alignment.

5. Close dispenser cover. Red light will turn o . The dispenser is ready.

ENGLISH

33,32 cm

33,60 cm

24,13 cm

1,07 m - 1,18 m

22,86 cm

12,36 cm

15,0 cm

1

2

4

3

Vurdering

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for Lotus Professional enMotion Impulse Håndkledispenser. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter Lotus Professional. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til Lotus Professional enMotion Impulse Håndkledispenser på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Alle bruksanvisninger for Lotus Professional Håndkledispensere
Flere håndbøker for Håndkledispensere

Relaterte produkter

Bruksanvisning

Lotus Professional enMotion Håndkledispenser

Bruksanvisning

Lotus Professional enMotion Recessed Håndkledispenser

Bruksanvisning

Lotus Professional Marathon Håndkledispenser

Bruksanvisning

Lotus Professional nextTurn Håndkledispenser