Bruksanvisning Kinzo 29604 Flisekutter

Bruksanvisning

a Tile cutter

Rip cut

Place the tile at the front edge against the front stop. (See “RIP CUT”

to the right). Position the tile so that the line to be cut is directly

over the scoring line, which is the line between the left and right

pads (See “Scoring Line” to the right). Place the table extension arms

under the tile for the best possible support. Adjust the cutting guide

by loosening the guide knob (See “Slide Rule Guide Knob” to the

right) and sliding it left or right to the desired cutting position. Lock

the cutting guide into place.

Scoring line

RIP CUT

Making the cut

Place the cutting wheel on the rear edge of the tile. Slide the wheel

forward by pushing the handle down while applying medium

pressure, scoring the tile surface glaze as the handle is pushed

forward (See “SCORING” photo below). It is important to make the

cut in one continuous motion, scoring the surface only once per tile.

After scoring, and without moving the tile, position the handle so

that the breaker bar is slightly inside the front edge of the tile and

front stop. Apply increasing pressure on the handle until the tile

snaps along the score line (See “SNAPPING” photo below).

Slide rule guide

knob

Scoring

line

SNAPPING

Press down

Diagonal cuts

The cutting guide can also assist in making diagonal cuts. First,

loosen the Slide Rule guide knob so that it can move side to side

and adjust to the size of the tile you are cutting. Then loosen the

knob on the Angle Cutting guide to allow the tile to rest against the

angle guide, positioning it for a diagonal cut. Tighten both knobs.

You are now ready to make the diagonal cut.

DIAGONAL CUT

Angle cutting

guide knob

Angle cutting guide

General maintenance

1. Oil should not be used on the Tile Cutters. Use of oil will cause eventual gumming and sticking of the movable parts

as the oil combines with dirt and ceramic tile dust. Use a soft dry cloth to clean the rails after each use.

2. The only part routinely needing replacement is the carbide scoring wheel.

SCORING

Slide to score surface

glaze

Breaker Bar

29604 manual.indd 2 07-11-11 13:51

Vurdering

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for Kinzo 29604 Flisekutter. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter Kinzo. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til Kinzo 29604 Flisekutter på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Alle bruksanvisninger for Kinzo Flisekutter
Flere håndbøker for Flisekutter

Ofte stilte spørsmål om Kinzo 29604 Flisekutter

Vårt supportteam søker etter nyttig produktinformasjon samt svar på ofte stilte spørsmål. Hvis du finner en feil i våre ofte stilte spørsmål, vennligst gi oss beskjed ved å benytte vårt kontaktskjema.