Bruksanvisning FERM TJM1008 Jekk

Bruksanvisning

EN

2 Ferm

TROLLEY JACK

Carfully read the instructions before you

use the trolley jack!

Contents

1. Machine data

2. Safety instructions

3. Operation

4. Maintenance

1. Machine data

Technical specification

Carrying capacity 2000 kg

Lifting height (min/max) 135/356 mm

2. Safety instructions

The following symbols are used in these

instructions for use:

Denotes risk of personal injury, loss of life

or damage to the machine in case of non-

observance of the instructions in this

manual.

Make sure the oil level is correct

Special safety rules

Non-observance of the following

instructions can cause personal injuries

and/or damage to the vehicle.

• Placethesaddleofthejackonlyinthespot

designed for this purpose. For the relevant

jackingpointspleaserefertoyourcar

instructions.

• Themaximumloadindicatedonthejackmust

never be exceeded.

• Thejackmustbeusedasaliftingdeviceonly.

• Alwaysplacethejackonahardandlevel

surface.

• Alwaysprotectthecarfromrollingaway.

Beforejackingupthecar,placechocksbehind

and in front of the wheels remaining on the

ground,ifnecessary.Putthecarinfirstgearor

put on the handbrake to further block the car.

• Makesuretoplacethejackinsuchawaythat

your hand is not underneath the car when

jackingitup.

• Makesurethejackishorizontal.

• Foryourownsafety,beforeworkingor

crawlingunderneaththecarjackupthecar

and support the shafts.

• Beforeusingtheshaftsupportsmakesure

they are in good condition.

3. Operation

Lifting

Turn the screw of the relief valve clockwise as far

aspossible.Thetrolleyjackisnowreadytolift.

Putthetrolleyjackhorizontallyonaflatsurface,

put the lever in the proper hole and start pumping

by moving the lever up and down.

Shaft supports

Afterjackingupthecartheshaftsupportsshould

be installed. Lower the car by turning the the

screwofthereleasevalveanticlockwise,untilthe

car rests on the supports. Never work under a car

whichonlyrestsonthetrolleyjack.

Lowering

Aftertheworkisfinished,thecarisliftedagain

until the shaft supports are clear. Remove the

shaft supports. Turn the screw of the relief valve

anticlockwise and the car will be lowered. The

further the screw is turned anticlockwise the faster

the car will be lowered.

4. Maintenance

Regular maintenance of your trolley jack

prevents problems!

• Onceamonththewheels,shaftsandpiston

rods should be lubricated with lubricating oil

and grease on the pivots of the lifting rods.

• Thetankcontaininghydraulicoilisaclosed

tank which usually does not require

maintenance.Whenfrequentlyused,butat

leastonceayear,theoilshouldbechanged.

For this purpose the top of the tank is fitted

with an oil drain plug.

Only hydraulic oil should be used for

refilling. Do not use engine or brake fluid.

Vurdering

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for FERM TJM1008 Jekk. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter FERM. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til FERM TJM1008 Jekk på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Alle bruksanvisninger for FERM Jekker
Flere håndbøker for Jekker

Relaterte produkter

Bruksanvisning

FERM TJM1001 Jekk

Bruksanvisning

FERM TJM1002 Jekk

Bruksanvisning

FERM JBM1001 Jekk

Bruksanvisning

FERM TJM1003 Jekk

Bruksanvisning

Rawlink 56692 Jekk

Bruksanvisning

Hamron 601-052 Jekk

Bruksanvisning

Biltema 15-847 Jekk

Bruksanvisning

Hamron 335-030 Jekk

Relaterte kategorier