Bruksanvisning FERM GRM1008 Høytrykksvasker

Trenger du en bruksanvisning for FERM GRM1008 Høytrykksvasker? Nedenfor kan du se og laste ned PDF-bruksanvisningen gratis på norsk. Dette produktet har for øyeblikket 3 vanlige spørsmål, 0 kommentarer og har 0 stemmer. Hvis dette ikke er bruksanvisningen du ønsker, vennligst kontakt oss.

Er ditt produkt defekt og finner du ikke løsningen i bruksanvisningen? Dra til en Repair Café for gratis hjelp til reparasjon.

Bruksanvisning

Loading…

Ferm 61
for the machine's power. The cores must have a
diameter of at least 1.5 mm
2
. When the extension
cable is on a reel, unroll the cable in its entirety.
All electrical connections e.g. extension cable, must
be of an approved waterproof type for outdoor use
and marked accordingly. Extension cables must be
threecore, one of which is EARTH.
SWITCH OFF THE MACHINE IMMEDIATELY
IN CASE OF
1. Malfunction in the mains plug, power cable or
damaging of cable.
2. Broken switch.
3. Smoke or stench of scorched insulation.
SPECIFIC SAFETY RULES
The USE and MAINTENANCE manual constitutes an
essential part of the cleaner equipment and should be
kept in a safe place for future reference. If you sell the
cleaner, the manual should be handed on to the new
owner.
- Before starting the cleaner, make sure that it is
receiving water correctly. Operating the cleaner
without water could damage the seals.
- Do not disconnect the plug by pulling on the
electrical cable.
- If you are too far from the object you wish to clean,
do not move the cleaner nearer by pulling on the high
pressure hose; use the handle provided.
- In versions not equipped with TSS device, do not
operate the cleaner for more than 1-2 minutes with
the gun closed as this could damage the seals.
- Protect the cleaner from freezing during the winter.
- Do not obstruct the ventilation grilles during
operation.
- The cross-section of any extension cables used must
be proportional to their length, i.e. the longer the
extension cable, the greater the cross-section;
cables with a protection level of "IPX5" must be used.
- Position the cleaner AS NEAR POSSIBLE to the
water supply.
- The packaging is easily recyclable, and must be
disposed of in compliance with the regulations in
force in the country of installation.
- Use the cleaner only with accessories and
replacement parts authorized by the manufacturer.
The use of original accessories and replacement
parts will ensure safe, trouble-free operation.
- The cleaner must be used standing on a secure, stable
surface.
- Avoid unintentional firing of the trigger. Do not carry
the lance/ trigger assembly with your hand over the
trigger. Always use the trigger lock mechanism.
- Ensure that the safety lock on the trigger is used,
when you have stopped using the pressure washer to
prevent accidental operation. (Fig. 6)
SAFETY "MUST NOTS"
- EXPLOSION OR POISONING.
DO NOT use the cleaner with inflammable or toxic
liquids, or any products which are not compatible
with the correct operation of the cleaner.
- INJURY HAZARD.
DO NOT direct the water jet towards people or
animals.
- ELECTRIC SHOCK HAZARD.
DO NOT direct the water jet towards the unit itself,
electrical parts or towards other electrical
equipment.
- SHORT CIRCUIT HAZARD.
DO NOT use the cleaner outdoors in case of rain.
- INJURY HAZARD.
DO NOT allow children or incompetent persons to
use the cleaner.
- ELECTRIC SHOCK HAZARD.
DO NOT touch the plug and/or socket with wet
hands.
- ELECTRIC SHOCK AND SHORT CIRCUIT
HAZARD.
DO NOT use the cleaner if the electrical cable is
damaged.
- EXPLOSION HAZARD.
DO NOT use the cleaner if the high pressure hose is
damaged.
- ACCIDENT HAZARD.
DO NOT jam the trigger in the operating position.
- ACCIDENT HAZARD.
Check that the data plates are affixed to the cleaner,
if not, inform your dealer. Cleaners without plates
must NOT be used as they are unidentifiable and
potentially dangerous.
- EXPLOSION HAZARD.
DO NOT tamper with or with or alter the
calibration of the safety valve.
- HAZARDOUS ALTERATION OF OPERATING
PERFORMANCE.
DO NOT alter the original diameter of the spray
head nozzle.
- ACCIDENT HAZARD.
DO NOT leave the cleaner unattended.
- SHORT CIRCUIT HAZARD. DO NOT move the
cleaner by pulling on the electrical cable.
SAFETY "MUSTS"
- SHORT CIRCUIT HAZARD.
All electrical conductors MUST BE PROTECTED
against the water jet.
- ELECTRIC SHOCK HAZARD.
The cleaner MUST ONLY BE CONNECTED to a
correctly earthed power supply.
- Use a Residual Current Device (RCD) of not more
than 30 mA, at the plug socket when using this
appliance.
- INJURY HAZARD.
The high pressure may cause materials to bounce off
surfaces at speed; therefore protective clothing and
safety goggles MUST BE WORN.
- ACCIDENTAL START-UP HAZARD.
Before doing work on the cleaner, REMOVE the
plug.
- INJURY HAZARD.
Before pressing the trigger, GRIP the gun firmly to
counteract the recoil.
- CONTAMINATION HAZARD.
COMPLY WITH the requirements of the local water
supply company. According to DIN 1988, power-jet
cleaners may only be connected to the mains
4 Ferm
Last ned bruksanvisning på norsk (PDF, 3.09 MB)
(Tenk på miljøet og bare skriv ut denne bruksanvisningen hvis det virkelig er nødvendig)

Loading…

Vurdering

La oss få vite hva du syns om FERM GRM1008 Høytrykksvasker ved å gi en produktbedømmelse. Vil du dele dine erfaringer med dette produktet eller stille et spørsmål? Legg igjen en kommentar nederst på siden.
Er du fornøyd med FERM GRM1008 Høytrykksvasker?
Ja Nei
Vær den første til å bedømme dette produktet
0 stemmer

Bli med i samtalen om dette produktet

Her kan du dele hva du synes om FERM GRM1008 Høytrykksvasker. Hvis du har et spørsmål, les først bruksanvisningen nøye. Be om en bruksanvisning kan gjøres ved å bruke vårt kontaktskjema.

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for FERM GRM1008 Høytrykksvasker. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter FERM. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til FERM GRM1008 Høytrykksvasker på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Merke FERM
Modell GRM1008
Kategori Høytrykksvaskere
Filtype PDF
Filstørrelse 3.09 MB

Alle bruksanvisninger for FERM Høytrykksvaskere
Flere håndbøker for Høytrykksvaskere

Ofte stilte spørsmål om FERM GRM1008 Høytrykksvasker

Vårt supportteam søker etter nyttig produktinformasjon samt svar på ofte stilte spørsmål. Hvis du finner en feil i våre ofte stilte spørsmål, vennligst gi oss beskjed ved å benytte vårt kontaktskjema.

Kan jeg bruke høytrykksvaskeren min til å rengjøre bilen min? Verifisert

Ja det kan du. Hold høytrykksvaskeren minst 20 centimeter fra bilen, og ikke overskrid et trykk på 110 Bar.

Det var nyttig (819) Les mer

Hvordan lagrer jeg en høytrykksspyler om vinteren? Verifisert

En høytrykksspyler er et produkt med deler som det renner vann gjennom. Tøm den alltid helt før oppbevaring for å forhindre frostskader. For å sikre at det ikke oppstår frostskader, er det best å holde en høytrykksspyler et frostfritt sted.

Det var nyttig (194) Les mer

Hva står PSI for? Verifisert

PSI står for Pound per Square Inch, noe som indikerer et trykk. Jo mer PSI en høytrykksvasker kan levere, desto kraftigere kan den rengjøre.

Det var nyttig (194) Les mer
Bruksanvisning FERM GRM1008 Høytrykksvasker

Relaterte produkter

Relaterte kategorier