Bruksanvisning Cotech 36-6078 Lampe

Bruksanvisning

UNITED KINGDOM • CUSTOMER SERVICE

tel 020 8247 9300 e-mail [email protected] internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZ

1

2

3

4

5

Ver. 20181204

Motion Sensor Ceiling Light

Art.no 36-6078

Please read theentire instruction manual before using theproduct and then save it for future

reference. Wereserve theright for any errors in text or images and any necessary changes

made to technicaldata. Intheevent of technical problems or other queries, please contact

our Customer Services.

Safety

• Installation should only be carried out by aqualified electrician.

• Theproduct is only intended for indooruse.

• Theproduct must be installed in accordance with current safety regulations to prevent

life-threatening accidents.

• Theproduct is intended for fixed installation.

• Theproduct is intended for ceiling installation.

Installation

Fixings

If thesupplied fixings are not suitable for thematerial which your ceiling is made of,

use appropriate fixings which will guarantee afirm anchorage.

Activation range

• Therange is controlled by DIP switches 1, 2 and 3

• 10–100 % of 6m

Duration of activation after motion detection

• Theactivation time is controlled by DIP switches 4, 5 and 6

• 5 sec – 30min

Light sensor sensitivity

• Thesensitivity is controlled by DIP switches 7, 8 and 9

• 2–50 lux oroff

Note: Thelux values are measured with thediffuser removed.

Whenthediffuser is fitted, thelux values are somewhatlower.

The luminous flux (brightness) of the ceiling light can be adjusted by setting

the DIP switches as shown in the table.

Luminous flux (lm) Power (W) 1 2

1100 15.5 − −

800 11.5 ON −

500 7.6 ON ON

Care and maintenance

Switch off thepower to theceiling light before cleaning. Clean thelight by wiping it with asoft,

dampcloth. Useamild detergent. Neveruse solvents or strong, abrasive cleaning agents.

Responsible disposal

This symbol indicates that this product should not be disposed of with general

household waste. This applies throughout theentire EU. In order to prevent

any harm to theenvironment or health hazards caused by incorrect waste

disposal, theproduct must be handed in for recycling so that thematerial can

be disposed of in aresponsible manner. When recycling your product, take it to

your local collection facility or contact theplace of purchase. They will ensure

that theproduct is disposed of in anenvironmentally sound manner.

Specifications

Only intended for indoor use (IP44).

If theplastic diffuser is damaged it must be replaced.

Minimum distance from combustible material: 0.1m.

Warning: Makesure that thepower is shut off before

starting theinstallation.

Thelight source in this product must only be replaced by

themanufacturer, aqualified service facility or aqualified

technician.

Note: Ifyou need to drill into theceiling, make sure to avoid any concealed electrical wiring.

1. Open theceiling light by twisting thediffuser anticlockwise and removingit.

2. Remove theplate holding theLED light by undoing the3retaining screws.

3. Knock out one of thepre-cut cable entries and fit thecablegland.

4. Pull thepower supply cable through thecablegland.

5. Fasten theceiling light directly to theceiling using the4outermost mounting holes or

fasten it to aceiling rose using the2 innermost mountingholes.

6. Connect thepower supply cable to theterminal block as shownbelow.

7. Re-assemble theceiling light in reverseorder.

Sensor

1. Light sensor

2. LED which comes on when

thesensor is activated

3. Controls for setting

theactivation range,

duration of activation and

light sensor sensitivity.

4. Out

5. In

Light fitting

Power supply 220–240 VAC,

50/60 Hz

Light source Built in LED

Power 15.5W

IP rating IP44

Colour temperature 3000K

Colour rendition Ra 80

Luminous flux 1100lm

800 lm

500 lm

Operating temperature −30°C ~ +40°C

Diam 34cm

Sensor

Recommended

installation height 2.5–6m

Detection range 12m

Sensitivity 10, 25, 50,

75 or 100 %

Lighting time 5 sec, 30 sec,

90 sec, 3min,

20min or 30min

Light sensor 2, 10, 25,

50 lux oroff

Motion sensor 0.5–3m/s

Detection angle 360º

Relay output for connecting up to 14additional

ceiling lights (36-6077), which are all activated

simultaneously.

Maxload: 800W resistive, 400W inductive

This ceiling light (36-6078) can be

interconnected with and control

multiple ceiling lights of article number

36-6077.

ON

1 2

Vurdering

Mer om denne håndboken

Vi forstår at det er fint å ha en papirhåndbok for Cotech 36-6078 Lampe. Du kan alltid laste ned bruksanvisningen fra nettsiden vår og skrive den ut selv. Hvis du vil ha en original bruksanvisning, anbefaler vi at du kontakter Cotech. De kan kanskje gi en original bruksanvisning. Leter du etter bruksanvisningen til Cotech 36-6078 Lampe på et annet språk? Velg ditt foretrukne språk på hjemmesiden vår og søk etter modellnummeret for å se om vi har det tilgjengelig.

Spesifikasjoner

Alle bruksanvisninger for Cotech Lamper
Flere håndbøker for Lamper

Ofte stilte spørsmål om Cotech 36-6078 Lampe

Vårt supportteam søker etter nyttig produktinformasjon samt svar på ofte stilte spørsmål. Hvis du finner en feil i våre ofte stilte spørsmål, vennligst gi oss beskjed ved å benytte vårt kontaktskjema.

Relaterte produkter

Bruksanvisning

Cotech 36-6707 Lampe

Bruksanvisning

Globo 15584-4HLMDS Lampe

Bruksanvisning

Globo 1581-3LMDS Lampe

Bruksanvisning

Westinghouse 6124140 Lampe

Bruksanvisning

Robens Suilven Lampe

Bruksanvisning

Eglo 49169 Lampe

Bruksanvisning

Eglo 99672 Lampe

Bruksanvisning

Elvita 116500 Lampe

Relaterte kategorier